Key Required - Directed DB3 Installation Manual

1 Key required!

For Convenience-Only programming, see next section.
Ensure vehicle is in a safe location, and cannot move forward during
1
programming. For vehicles equipped with a manual transmission, make sure the
gearshift is in the neutral position.
The harnesses must be connected in this exact order:
1. Connect the 14-pin.
2
2. Connect the 12-pin.
3. Connect the 10-pin.
When the LED turns on solid red, proceed with the next step.
Insert the key and turn the ignition ON and OFF twice.
3 The LED starts flashing orange slowly.
Turn the ignition off by removing the key from the ignition barrel, remove
1.
the module from the vehicle and reconnect it to your computer.
4
The website will automatically recognize that you are moving onto the
second phase of the programming sequence.
Click Submit Key2GO Request.
2.
When the configuration is completed, reconnect the module.
5 The LED will turn on solid green for 3 seconds, then turn off.
6
Remove the key from the ignition barrel.
You have successfully completed the module programming sequence.
12
403.FORD4 3.25 2017 Ford Escape
©2023 Directed. All rights reserved.