Fastening Via Bt-2Sb10 Swiveling Mounting Brackets - Leuze electronic MLC 500 Original Operating Instructions

The wall mounting through threaded holes makes it possible to lift the mounting bracket after the screws
have been loosened over the connection cap. Therefore, the mounting brackets do not need to be removed
from the wall when exchanging the device. Loosening the screws is sufficient.
For increased mechanical loads, mounting brackets are also available in a vibration-damped version
(BT-2HF-S) (see chapter 15 "Order guide and accessories").
Fig. 6.8: Mounting via swivel mount BT-2HF
6.2.5

Fastening via BT-2SB10 swiveling mounting brackets

Fig. 6.9: Mounting via swiveling mounting brackets BT-2SB10
For larger protective field heights > 900 mm, the use of the BT-2SB10 swiveling mounting brackets is rec-
ommended (see chapter 15 "Order guide and accessories"). For increased mechanical requirements, these
are also available as vibration-damped version (BT-2SB10-S). Depending on the installation situation, envi-
ronmental conditions and protective field length (> 1200 mm), other mounting brackets may also be neces-
sary.
Leuze electronic MLC 520 Host/Guest
Mounting
33