Viewing Home Screen; Setup Menu; View Menu - Dell EMC PowerEdge GPH2C Installation And Service Manual

Viewing Home screen

The Home screen displays user-configurable information about the system. This screen is displayed during normal system
operation when there are no status messages or errors. When the system turns off and there are no errors, LCD enters the
standby mode after five minutes of inactivity. Press any button on the LCD to turn it on.
Steps
1. To view the Home screen, press one of the three navigation buttons (Select, Left, or Right).
2. To navigate to the Home screen from another menu, complete the following steps:
a. Press and hold the navigation button till the up arrow
b. Navigate to the Home icon
c. Select the Home icon.
d. On the Home screen, press the Select button to enter the main menu.

Setup menu

NOTE: When you select an option in the Setup menu, you must confirm the option before proceeding to the next action.
Table 28. Setup menu
Option Description
iDRAC Select DHCP or Static IP to configure the network mode. If Static IP is selected, the available fields
are IP, Subnet (Sub), and Gateway (Gtw). Select Setup DNS to enable DNS and to view domain
addresses. Two separate DNS entries are available.
Set error Select SEL to view LCD error messages in a format that matches the IPMI description in the SEL. This
enables you to match an LCD message with an SEL entry. Select Simple to view LCD error messages in
a simplified user-friendly description. For information about the event and error messages generated by
the system firmware and agents that monitor system components, go to
Code, type the error code, and then click Look it up..
Set home Select the default information to be displayed on the Home screen. See
and option items that can be set as the default on the Home screen.

View menu

NOTE: When you select an option in the View menu, you must confirm the option before proceeding to the next action.
Table 29. View menu
Option
iDRAC IP
MAC
Name
Number
Power
Temperature
112 System diagnostics and indicator codes
using the up arrow .
Description
Displays the IPv4 or IPv6 addresses for iDRAC9. Addresses include DNS (Primary and
Secondary), Gateway, IP, and Subnet (IPv6 does not have Subnet).
Displays the MAC addresses for iDRAC, iSCSI, or Network devices.
Displays the name of the Host, Model, or User String for the system.
Displays the Asset tag or the Service tag for the system.
Displays the power output of the system in BTU/hr or Watts. The display format can be
configured in the Set home submenu of the Setup menu.
Displays the temperature of the system in Celsius or Fahrenheit. The display format can
be configured in the Set home submenu of the Setup menu.
is displayed.
qrl.dell.com > Look Up > Error
View menu section for the options