Table of Contents
Advertisement
TL-SG3109/TL-SL3428/TL-SL3452
3.2.1 Desktop or Shelf Installation
When installing the switch on a desktop or shelf, the rubber feet included with
the device should first be attached. Attach these cushioning feet on the bottom
at each corner of the device.
Ensure the surface is be able to support the weight of the device and the
device cables.
To install the device on a surface, perform the following:
1. Attach the rubber feet on the bottom of the device.
2. Set device down on a flat surface, while leaving 2 inches on each side and
5 inches at the back.
3. Ensure that the device has proper ventilation by allowing adequate space
for ventilation between the device and the objects around the device.
3.2.2 Rack Installation
The device can be mounted in an EIA standard-sized, 19-inch rack, which can
be placed in a wiring closet with other equipment. To install, the device the
mounting brackets must first be attached on the devices's sides.
Note
Disconnect all cables from the unit before mounting the device in a rack or
cabinet.
When mounting multiple devices into a rack, mount the devices from the
bottom up.
To install the device in a rack, perform the following:
1. Place the supplied rack-mounting bracket on one side of the device
ensuring the mounting holes on the device line up to the mounting holes
Gigabit Managed Switch Family Installation Guide
18
Hide quick links:
Advertisement
Table of Contents
