Initial Configuration - TP-Link TL-SG3109 Installation Manual

TL-SG3109/TL-SL3428/TL-SL3452
Note
After making any configuration changes, the new configuration must be saved
before rebooting. To save the configuration, enter:
console# copy running-config startup-config

4.4.1 Initial Configuration

Initial configuration, which starts after the device has booted successfully,
includes static IP address and subnet mask configuration, and setting user
name and privilege level to allow remote management. If the device is to be
managed from an SNMP-based management station, SNMP community
strings must also be configured. The following configurations are completed:
The initial simple configuration uses the following assumptions:
The device was never configured before, and is in the same state as when

it was received.
The device booted successfully.

The Serial connection is established and the console prompt is displayed

on the screen of a VT100 terminal device. (Press the <Enter> key several
times to verify that the prompt displays correctly.)
The device is not configured with a default user name and password.

The initial device configuration is through the Serial port. After the initial
configuration, the device can then be managed either from the already
connected Serial port or remotely through an interface defined during the initial
configuration.
The initial configuration consists of the following:
Gigabit Managed Switch Family Installation Guide
27