Site Requirements; Unpacking; Package Contents - TP-Link TL-SG3109 Installation Manual

TL-SG3109/TL-SL3428/TL-SL3452
Cautions
Ensure the air flow around the front, sides, and back of the switch is not

restricted.
Ensure the cooling vents are not blocked.

Do not install the switch in an environment where the operating ambient

temperature might exceed 40ºC (104ºF).

3.1.2 Site Requirements

The device is placed on a table-top. Before installing the unit, verify that the
location chosen for installation meets the following site requirements.
General — Ensure that the power supply is correctly installed.

Power — The unit is installed within 1.5 m (5 feet) of a grounded, easily

accessible outlet 100-240 VAC, 50-60 Hz.
Clearance — There is adequate frontal clearance for operator access.

Allow clearance for cabling, power connections and ventilation.
Cabling — The cabling is routed to avoid sources of electrical noise such

as radio transmitters, broadcast amplifiers, power lines and fluorescent
lighting fixtures.
Ambient Requirements — The ambient unit operating temperature

range is 0 to 40ºC (32 to 104ºF) at a relative humidity of up to 95%, non-
condensing. Verify that water or moisture cannot enter the device casing.

3.1.3 Unpacking

3.1.3.1 Package Contents

While unpacking Cedar device, ensure that the following items are included:
The device

An AC power cable

Gigabit Managed Switch Family Installation Guide
16