TL-SG3109/TL-SL3428/TL-SL3452
4.2.1 Device Port Default Settings
The following table describes the device port default settings.
Function
Port speed and mode
Port forwarding state
Head of line blocking prevention
Flow Control
Back Pressure
Note
These default settings can be modified once the device is installed.
4.3 Booting the Device
The assumed bootup information is as follows:
The device is delivered with an empty configuration.
To boot the device, perform the following steps:
1. Ensure that the device port console is connected to a VT100 terminal
device or VT100 terminal emulator.
2. Connect the device to the AC receptacle.
3. Activate the AC power receptacle (if required).
The device goes through Power On Self Test (POST). POST runs every time
the device is initialized and checks hardware components to determine if
Gigabit Managed Switch Family Installation Guide
Default Settings
• 100Mbps Auto-negotiation for 10/100 Base-TX
Ports
• 1000Mbps Auto-negotiation for 10/100/1000
Base-TX Ports
Enabled
On (Enabled)
Off
Off
Table 5: Port Default Setting
24