TL-SG3109/TL-SL3428/TL-SL3452
Section 4. Starting and Configuring the Device
This section describes the initial device configuration and includes the
following topics:
Configuring the Terminal
Installation Procedure
Booting the Device
Configuration Overview
Advanced Configuration
Startup Procedures
4.1 Configuring the Terminal
After completing all external connections, connect a terminal to the device to
monitor the boot and other procedures.
To configure the device, the terminal must be running terminal emulation
software.
Ensure that the terminal emulation software is configured as follows:
1. Connect the Chassis serial port to the switch module. The baud rate
automatically boots up at 38400.
2. Set the data format to 8 data bits, 1 stop bit, and no parity.
3. Set Flow Control to none.
4. Under Properties, select VT100 for Emulation mode.
5. Select Terminal keys for Function, Arrow, and Ctrl keys. Ensure that the
setting is for Terminal keys (not Windows keys).
Note
When using HyperTerminal with Microsoft
Gigabit Managed Switch Family Installation Guide
®
Windows 2000, make sure that
22