Section One Introduction (Users Instructions) - Infinity 600 FL Owner's Manual

SECTION ONE Introduction (users instructions)

Consumer protection information
As manufacturers and suppliers of heating products, we take every care, as far as is reasonably practicable, that these
products are so designed and constructed as to meet the general safety requirement when properly used and installed.
To this end, our products are thoroughly tested and examined before despatch.
IMPORTANT NOTICE: Any alteration that is not approved by the appliance manufacturer could invalidate the approval
of the appliance, operation of the warranty and could affect your statutory rights.
Health and Safety notice
Important
This appliance could contain some of the materials, indicated below, that could be interpreted as being injurious to
health and safety. It is the users / installers responsibility to ensure that the necessary personal protective clothing is
worn when handling these materials, see below for information.
Artificial Fuels, Mineral Wool, Insulation Material, Refractory/Ceramic Fibres, Glass Yarn - may be harmful if inhaled,
may be irritating to skin, eyes, nose and throat.
When handling avoid inhaling and contact with skin or eyes. Use disposable gloves, facemasks and eye protection.
After handling wash hands and other exposed parts. If a vacuum is used for cleaning the coals or cleaning after servicing
/ installation it is recommended that it be of the type fitted with a HEPA filter.
Disposal of refractory/ceramic materials. To keep dust to a minimum these materials should be securely wrapped in
polythene and be clearly labelled 'RCF waste'. These materials are not classified as 'hazardous waste and should be
disposed of at a site licensed for the disposal of industrial waste.
INTRODUCTION

The 600 FL as been designed and tested to the requirements of EN 613 and is suitable for use in GB (Great
Britain) and IE (Ireland).

The 600 FL incorporates a single gas control, which selects ignition pilot, with variable setting between low
and high settings and is operated via remote control. The system is powered by a battery pack; therefore no
mains electrical supply is required.

Like all appliances incorporating an aerated burner a low frequency noise may be heard, this may be more
noticeable on the low setting.

The 600 FL incorporates a safety device in the form of an Oxygen Depletion System, which constantly
monitors the oxygen in the room and will cause the fire to switch off if the oxygen level reduces, for instance
due to insufficient ventilation or a blocked flue.

If this regularly occurs do not attempt to relight the appliance until a qualified engineer has checked it, the
problem may not be due to lack of air or a defective flue.

The pilot can be left on (standby setting) or the pilot can be extinguished and relit each time the fire is used.
www.charltonandjenrick.co.uk 5 LT6125 (ISS 13)