Table of Contents
Advertisement
11.43
Checking the rubber grips
SERVICE WORK ON THE CHASSIS 11
–
Remove the right side panel. (
–
Remove the fuel tank.
Main work
–
Check the throttle cable routing.
Both throttle cables must be routed to the throttle valve
body side by side on the back of the handlebars and above
the fuel tank roller. Both throttle cables must be secured
behind the rubber strap of the fuel tank support.
»
If the throttle cable routing is not as specified:
–
Correct the throttle cable routing.
A01085-10
Finishing work
–
Install the fuel tank.
–
Install the right side panel. (
–
Mount the seat. (
–
Check the rubber grips on the handlebar for damage, wear,
and looseness.
Info
The rubber grips are vulcanized onto a sleeve on the
left and onto the handle tube of the throttle grip on the
right. The left sleeve is clamped onto the handlebar.
The rubber grip can only be replaced with the sleeve
or the throttle tube.
401197-01
»
If a rubber grip is damaged or worn:
–
Change the rubber grip.
–
Check that screw
Guideline
Screw, fixed
grip
A
Diamond
figure.
F03684-10
p. 68)
(
p. 70)
(
p. 72)
p. 68)
p. 63)
1
is firmly seated.
M4
5 Nm (3.7 lbf ft)
must be positioned visibly as shown in the
®
Loctite
243™
79
Advertisement
Table of Contents
