Table of Contents
Advertisement
12 BRAKE SYSTEM
88
–
Remove screws
–
Press back the brake linings by slightly tilting the brake
caliper laterally on the brake disc. Carefully pull the brake
caliper up and off the brake disc.
–
Press the brake piston back into the basic position and
ensure that brake fluid does not flow out of the brake fluid
reservoir; extract some if necessary.
Info
A01183-10
Do not operate the hand brake lever if the brake
caliper has been removed.
–
Remove cotter pins
brake linings.
–
Clean the brake caliper and the brake caliper bracket.
F03696-10
–
Check that spring plate
pad sliding plate
correctly.
F03692-10
–
Insert the new brake linings, insert pin
5
pins
.
Info
Always change the brake linings in pairs.
To make it easier to mount the pin, push the brake
linings against the retainer spring.
Make sure the brake linings and retainer spring are
seated correctly.
F03696-10
–
Position the brake caliper.
–
Mount and tighten screws
Guideline
Screw, front
brake caliper
–
Operate the hand brake lever repeatedly until the brake lin-
ings are in contact with the brake disc and there is a pressure
point.
A01184-10
4
.
5
6
, pull out pin
, and remove the
7
in the brake caliper and brake
8
in the brake caliper bracket are seated
6
, and mount cotter
4
.
M8
25 Nm (18.4 lbf ft)
Loctite
®
243™
Advertisement
Table of Contents
