Table of Contents
Advertisement
SERVICE WORK ON THE CHASSIS 11
–
Check the chain sliding guard for wear.
»
If the lower edge of the chain pins is in line with, or below,
the chain sliding guard:
–
Change the chain sliding guard.
–
Check that the chain sliding guard is firmly seated.
»
If the chain sliding guard is loose:
–
Tighten screws on the chain sliding guard.
Guideline
Screw, chain
sliding guard
A01086-10
–
Check the chain sliding piece for wear.
»
If the lower edge of the chain pins is in line with or below
the chain sliding piece:
–
Change the chain sliding piece.
–
Check that the chain sliding piece is firmly seated.
»
If the chain sliding piece is loose:
–
Tighten screw on the chain sliding piece.
Guideline
Screw, chain slid-
ing piece
A01087-10
–
Check the chain guide with a slide gage for dimension
Minimum thickness
the chain guide
»
If the measured value is less than the specified value:
–
Change the chain guide.
F03687-10
M6
6 Nm (4.4 lbf ft)
Loctite
M8
15 Nm
(11.1 lbf ft)
C
6 mm (0.24 in)
of
®
243™
C
.
77
Advertisement
Table of Contents
