16.3
Adjusting the characteristic map of the throttle response
Info
On the throttle grip, the characteristic map of the throttle response is changed by changing the guide
plate.
A guide plate with a different characteristic map is supplied.
Main work
–
Move the handlebar to the straight-ahead position.
–
Push back sleeve
–
2
Loosen nut
–
Turn adjusting screw
–
4
Loosen nut
–
Push cold start button
–
Turn adjusting screw
to the basic position when the throttle grip is turned to the
front.
–
4
Tighten nut
–
Turn adjusting screw
cable at the throttle grip.
Guideline
Play in throttle cable
–
2
Tighten nut
–
Slide on sleeve
A01080-10
–
Check the throttle grip for smooth operation.
Finishing work
–
Check the play in the throttle cable. (
–
Install the fuel tank.
–
Install the right side panel. (
–
Mount the seat. (
Main work
–
Push back sleeve
–
Remove screws
–
Detach the throttle cables and take off the grip tube.
F03743-10
TUNING THE ENGINE 16
1
.
.
3
in as far as possible.
.
6
all the way to the stop.
5
so that the cold start button moves
.
3
so that there is play in the throttle
3 ... 5 mm (0.12 ... 0.2 in)
.
1
.
p. 112)
(
p. 72)
p. 68)
p. 63)
1
.
2
3
and half-shells
.
113