Checking The Pt Setting Status - Omron NT30C-ST141-E Operation Manual

System Maintenance

3-9-3 Checking the PT Setting Status

Checking the PT Setting Status
Reference
114
Display the NT30/30C settings by using the menu operation from the System
Menu shown below.
[ SYSTEM MENU ]
Quit
Transmit Mode
Maintenance Mode
[ MAINTENANCE MENU ]
Quit
Display History
I/O Check
PT Settings
Init. Memory
< PT SETTINGS >
Screen Memory Size
PT Control Area
PT Notify Area
SW2-1 System Reserved
SW2-2ON:Memory Protect
SW2-3 ON:Not Display System Menu
SW2-4 ON:Init. Screen Memory
SW2-5 System Reserved
SW2-6 System Reserved
SW2-7 ON:Erase System Program
SW2-8 For the Terminater Valid, Turn ON
• The current NT30/30C setting status will be displayed.
• Pressing the Quit touch switch will exit the PT Settings display and cause the
NT30/30C to return to the Maintenance Menu.
SW2 pin 6 is factory-set to OFF. Since it is not possible to display English with
this setting, it must be set to ON before installing the system program. (Use the
installer.)
Select "Maintenance Mode."
Select "PT Settings."
Memory Switch
Quit
512k
DM0100
DM0200
ON OFF
Section 3-9