System Health Monitor - Supermicro X6DLP-EG2 User Manual

X6DLP-4G2/X6DLP-EG2 User's Manual
USB Confi guration
This feature allows the user to confi gure the USB settings.
USB Function
This feature allows you to enable the USB Ports. The options are Disabled and
Enabled.
Legacy USB Support
Select Enabled to enable USB Legacy support. Disable legacy support if there
are no USB devices installed in the system. The options are Disabled, Enabled,
and Auto.
USB 2.0 Controller
This setting allows you to enable or disable the USB 2.0 Controller. The options
are Disabled and Enabled.
USB 2.0 Controller Mode
This setting allows you to confi gure the USB 2.0 Controller Mode. The options are
Hi-Speed (480 Mbps) and Full Speed-(12Mbps).
USB Mass Storage Device Confi gurations
USB Mass Storage Reset Delay
This setting allows you to decide how long the system should wait in an attempt
to detect the presence of a USB Mass Storage Device before it issues a start
command the system to proceed with the next operation during POST. The
options are 10 Seconds, 20 Seconds, 30 Seconds and 40 Seconds.
Emulation Type
If set to Auto, USB devices that are smaller than 530MB will be emulated as
fl oppy and the remaining will be emulated as an HDD. The Forced FDD option
will allow you to confi gure an HDD formatted drive to boot as an FDD (eg. Zip
Drive). The options are Auto, Floppy, Forced FDD, Hard Disk, and CD ROM.

System Health Monitor

This feature allows the AMI BIOS to automatically display the status of the follow-
ing items:
CPU Overheat Temperature
This feature allows the user to set the CPU Overheat temperature threshold. The
o
options range from 65 C to 90
The default setting is 78
Doctor III settings take precedence over the BIOS settings. When fi rst installed,
Supero Doctor III adopts the temperature threshold settings previously set in the
BIOS. Any subsequent changes to these thresholds must be made within Supero
Doctor, since the SD III settings override the BIOS settings. For the Windows OS
to adopt the BIOS temperature threshold settings, please change the SDIII settings
to be the same as those set in the BIOS.
o
C. Use the <+> and <-> keys to set the desired setting.
o
C. *Note: In the Windows OS environment, the Supero
4-14