Power Fault - Supermicro X6DLP-EG2 User Manual

X6DLP-4G2/X6DLP-EG2 User's Manual
VGA Connector
A VGA connector (J1) is located
next to the GLAN1 on the IO
backplane. Refer to the board
layout below for the location.

Power Fault

Connect a cable from your power
supply to the PW4 header to provide
warning of power supply failure. This
warning signal is passed through the
PWR_LED pin to indicate of a power
failure on the chassis. See the table
on the right for pin defi nitions.
A
GLAN1
Battery
GLAN2
GLAN2
Note: This feature is only available when using
redundant Supermicro power supplies.
B
8-pin
PW3
PWR
2-18
PWR Fail
Pin Defi nitions
Pin# Defi nition
1 PWR 1 Fail Signal
2 PWR 2 Fail Signal
3 PWR 3 Fail Signal
4 PWR 4 Fail Signal
A. VGA
B. PWR Fault