Clear Cmos; Watch Dog - Supermicro X6DLP-EG2 User Manual

CMOS Clear
JBT1 is used to clear CMOS. Instead of pins, this "jumper" consists of contact
pads to prevent the accidental clearing of CMOS. To clear CMOS, use a metal
object such as a small screwdriver to touch both pads at the same time to short
the connection. Always remove the AC power cord from the system before clear-
ing CMOS. Note: For an ATX power supply, you must completely shut down the
system, remove the AC power cord and then short JBT1 to clear CMOS. Do not
use the PW_ON connector to clear CMOS.

Watch Dog

JWD controls Watch Dog, a system
monitor that takes action when a soft-
ware application hangs.
1-2 to reset the system if a program
hangs. Close pins 2-3 to generate a
non-maskable interrupt for the program
that hangs (*This requires software
implementation). Watch Dog must also
be enabled in the BIOS.
GLAN1
Battery
GLAN2
GLAN2
Close pins
8-pin
PW3
PWR
B
A
2-21
Chapter 2: Installation
Watch Dog
Jumper Settings (JWD)
Jumper Setting Defi nition
Pins 1-2 Reset
Pins 2-3 NMI
Open Disabled
A. Clear CMOS
B. WD