Table of Contents
Advertisement
S
S
UPER
ERVER 6024H-TR/6024H-T User's Manual
Figure 6-1. Front and Rear Chassis Views
Serial ATA Drives (6)
Keyboard/Mouse Ports
USB Ports
6024H-TR shown: the 6024H-T is identical but with only a single power supply.
6-2
Control Panel
The control panel (located on the front of the chassis) must be connected to the
JF1 connector on the serverboard to provide you with system status indications. A
ribbon cable has bundled these wires together to simplify the connection. Connect
the cable from JF1 on the serverboard to JP4 on the Control Panel PCB (printed
circuit board). Make sure the red wire plugs into pin 1 on both JF1 and JP4. Pull
all excess cabling out of the airfl ow path. The LEDs inform you of system status.
See Chapter 3 for details on the LEDs and the control panel buttons. Details on
JF1 can be found in Chapter 5.
Floppy Drive
5.25" Drive Bay
Parallel Port
COM1 Port
VGA Port
6-2
Slim CD-ROM Drive
System Reset
Main Power
7 Low-Profi le PCI Slots
Ethernet Ports
Control Panel
NIC 2
NIC 1
Advertisement
Table of Contents
