Table of Contents
Advertisement
5. Screw in two diagonal screws until just snug (do not fully tighten), then do the
same with the remaining two diagonal screws. Finish by fully tightening all four
screws (see Figure 5-2).
6. If installing two processors, repeat these steps to install the second processor
in the CPU #2 slot.
Figure 5-1. 604-pin PGA Socket: Empty and with Processor Installed
Warning!
the CPU. If the lever is only partly raised, damage to the socket or
CPU may result.
Figure 5-2. Heatsink Installation (optional)
Chapter 5: Advanced Serverboard Setup
Make sure you lift the lever completely when installing
5-3
Advertisement
Table of Contents
