Table of Contents
Advertisement
Onboard Controllers/Ports
One fl oppy drive controller and two onboard ATA/100 controllers are provided to
support up to four IDE hard drives or ATAPI devices. The color-coded I/O ports
include one COM port (an additional COM header is located on the serverboard), a
VGA (monitor) port, a parallel port, two USB 2.0 ports, PS/2 mouse and keyboard
ports and two gigabit Ethernet ports. Two front side USB ports are also included
on the front of the chassis.
ATI Graphics Controller
The X6DHT-G features an integrated ATI video controller based on the Rage XL
graphics chip. Rage XL fully supports sideband addressing and AGP texturing.
This onboard graphics package can provide a bandwidth of up to 512 MB/sec over
a 32-bit graphics memory bus.
Other Features
Other onboard features that promote system health include onboard voltage moni-
tors, a chassis intrusion header, auto-switching voltage regulators, chassis and CPU
overheat sensors, virus protection and BIOS rescue.
1-3
Server Chassis Features
The SuperServer 6024H-TR/6024H-T is a high-end, scaleable server platform de-
signed with today's most state-of-the-art features. The following is a general outline
of the main features of the SC823T-R500LP/SC823T-550LP server chassis.
System Power
The SC823T-R500LP features a redundant 500W power supply that consists of two
separate power supply modules. Under normal operation, both modules share the
load and run continuously. If one fails, the other module will pick up the load and
keep the system running without interruption. A failed power supply module will
illuminate the power fail LED. The power supply modules are hot-swappable, so
you don't have to power down the system to replace a module.
The SC823T-550LP features a single 550W power supply.
Chapter 1: Introduction
1-3
Advertisement
Table of Contents
