Jlan Enable/Disable; Vga Enable/Disable; Watch Dog Enable/Disable - Supero SuperServer 6024H-TR User Manual

S
UPERSERVER 6024H-TR/6024H-T User's Manual

JLAN Enable/Disable

Change the setting of jumper JPL1 to
enable or disable the onboard LAN
ports (JLAN1 and JLAN2) on the
serverboard. See the table on the
right for jumper settings. The default
setting is enabled

VGA Enable/Disable

JPG1 allows you to enable or disable
the VGA port. The default position is
on pins 1 and 2 to enable VGA. See
the table on the right for jumper set-
tings.

Watch Dog Enable/Disable

JWD controls the Watch Dog func-
tion. Watch Dog is a system monitor
that can reboot the system when a
software application is "hung up". Pins
1-2 will cause WD to reset the system
if an application is hung up. Pins 2-3
will generate a non-maskable interrupt
signal for the application that is hung
up. See the table on the right for jump-
er settings. Watch Dog must also be
enabled in BIOS.
Note: When enabled, the user needs
to write their own application software
in order to disable the Watch Dog Tim-
er.
JLAN Enable/Disable
Jumper Settings (JPL1)
Jumper Setting
Pins 1-2*
Pins 2-3
VGA Enable/Disable
Jumper Settings (JPG1)
Jumper Setting
Pins 1-2*
Pins 2-3
Watch Dog
Jumper Settings (JWD)
Jumper Setting
Pins 1-2*
Pins 2-3
Open
5-18
Defi nition
Enabled
Disabled
Defi nition
Enabled
Disabled
Defi nition
Reset
NMI
Disabled