Drive Bay Installation/Removal - Supero SuperServer 6024H-TR User Manual

S S
UPER ERVER 6024H-TR/6024H-T User's Manual
Cover Release Buttons
Motherboard
6-4

Drive Bay Installation/Removal

Accessing the Drive Bays
Serial ATA Drives: You do not need to access the inside of the chassis or remove
power to replace or swap SATA drives. Proceed to the next step for instructions.
Note: You must use standard 1" high, Serial ATA drives in the SuperServer 6024H-
TR/6024H-T.
CD-ROM/Floppy Disk Drive: For installing/removing the CD-ROM or fl oppy disk
drive, you will need to gain access to the inside of the server by removing the top
cover of the chassis. Proceed to the "CD-ROM and Floppy Drive Installation" sec-
tion later in this chapter for instructions.
5.25" Drive Bay: For installing/removing a component in the 5.25" drive bay, proceed
to the "5.25" Drive Bay Installation" section later in this chapter for instructions.
Figure 6-2. System Cooling Fans
Top Chassis
Cover (removed)
System Memory
System Cooling Fans
6-4
Power Supply