Table of Contents
Advertisement
SUPERSERVER 6024H-TR/6024H-T User's Manual
3-3
Control Panel LEDs
The control panel located on the front of the chassis has several LEDs (six on the
6024H-TR and fi ve on the 6024H-T). These LEDs provide you with critical informa-
tion related to different parts of the system. This section explains what each LED
indicates when illuminated and any corrective action you may need to take.
Power Fail (6024H-TR only): Indicates a power supply module has failed.
The second power supply module will take the load and keep the system running
but the failed module will need to be replaced. Refer to Chapter 6 for details on
replacing the power supply. This LED should be off when the system is operating
normally.
Overheat/Fan Fail: When this LED fl ashes, it indicates a fan failure. When
on continuously it indicates an overheat condition, which may be caused by cables
obstructing the airfl ow in the system or the ambient room temperature being too
warm. Check the routing of the cables and make sure all fans are present and
operating normally. You should also check to make sure that the chassis covers
are installed. Finally, verify that the heatsinks are installed properly (see Chapter
5). This LED will remain fl ashing or on as long as the indicated condition exists.
1
NIC1: Indicates network activity on the LAN1 port when fl ashing.
3-2
Advertisement
Table of Contents
