Control Panel Leds - Supero FatTwin F617H6-FT+ User Manual

FatTwin F617H6-FT+/FTPT+ USER'S MANUAL
•
Power: The main power button on each of the four control panels is used to
apply or remove power from the power supply to each of the four systems in
the chassis. Turning off system power with this button removes the main power,
but keeps standby power supplied to the system. Therefore, you must unplug
system before servicing. The poer button has a built-in LED which will turn green
when the power is on.
•
UID: When used with a UID compatible motherboard, the UID button is used
to turn on or off the blue light function of the LED. This is built into the front
side of the UID button and at the rear end of each motherboard node, for those
motherboards which support it. Once the blue light is activated, the unit can be
easily located in very large racks and server banks.
3-3

Control Panel LEDs

The four control panels are located on the front handle of the F414IS chassis.
Each control panel has two additional LEDs. These LEDs provide you with critical
information related to different parts of the system. This section explains what each
LED indicates when illuminated and any corrective action you may need to take.
•
Information LED: See the following table for the status shown by this LED.
Status
Continously on and red
Blinking red (1 Hz)
Blinking red (0.25 Hz)
Solid blue
Blinking blue (300 msec)
Information LED
Description
An overheat ocondition has occured. (This may be caused by cable congestion.)
Fan failure: check for an inoperative fan.
Power failure: check for an inoperative power supply.
Local UID has been activated. Use this function to locate the server in a rack
environment.
Remote UID has been activated. Use this function to locate the server from a
remote location.
3-2