Indicators During Sending/Receiving Operation; Responding To An Attention Indicator Flashes - Kyocera FAX System 12 Operation Manual

Troubleshooting > Indicators During Sending/Receiving Operation

Indicators During Sending/Receiving Operation

The [Data] indicators show the fax transmission status.
• The [Data] indicator blinks during fax transmission and reception.
• The [Data] indicator is lit when there is source data stored in the memory for delayed transmission.

Responding to an Attention Indicator Flashes

If the [Attention] indicator flashes, select the [Status/Job Cancel] key to check an error message. If the message is not
indicated on the touch panel when the [Status/Job Cancel] key is pressed or the [Attention] indicator flashes, check
the following.
Symptom
Cannot send fax.
Checkpoints
Is the modular cord
connected correctly?
Is Permitted FAX No. or
Permitted ID No. registered
correctly?
Has a communication error
occurred?
Is the destination FAX line
busy?
Does the destination FAX
machine respond?
Is there an error other than
above?
11-2
Corrective Actions
Connect the modular cord correctly.
Check Permitted FAX No. and
Permitted ID No.
Check error codes in the TX/RX
Result Report and Activity Report. If
the error code starts with "U" or "E",
perform the corresponding
procedure.
Send again.
Send again.
Contact your Service
Representative.
Reference
Page
—
8-17
11-6
—
—
—