Kyocera FAX System 12 Operation Manual page 200

Fax Settings > Default FAX settings
Fax Transmission
[Home] key > [...] > [System Menu] > [Function Settings] > [Fax/iFax] > [Fax Transmission]
Item
Retry Times
Always Continuous Scan
with Platen
Port 1/ Dialing Mode
Port (Inch version only)
*1
2
ECM TX
TX Start Speed
(Port1)
*1 This function is displayed when 2 optional FAX Kits (Dual FAX option) are installed.
The number of retry times can be changed.
Value: 0 to 14
This item is included in the Quick Setup Wizard.
Quick Setup Wizard (page 2-11)
To scan a document on the document glass and send a fax, Always Continuous Scan
with Platen is set.
Value: On, Off
Select the telephone line according to the type you are contracted with. Please note
that selecting a wrong telephone line will prevent you from sending fax.
Value: Tone(DTMF), Pulse(10PPS)
This item is included in the Quick Setup Wizard.
Quick Setup Wizard (page 2-11)
Set whether ECM TX is performed.
ECM is a communication mode specified by the ITU-T (International
Telecommunication Union) that retransmits data when an error occurs. Fax machines
that have ECM mode check for errors as they communicate, preventing distortion of
the image due to noise on the line and other conditions.
Value: On, Off
NOTE
When there is a large amount of noise on the line, communication may take slightly longer than
when [Off] is selected.
Set the TX Start Speed.
When communication conditions are bad, the fax may not be transmitted correctly. In
that case, set a lower TX Start Speed.
Value: 9600bps, 14400bps, 33600bps
NOTE
Normally this should be used with the default setting.
8-11
Description