Indicators During Sending/Receiving Operation; Responding To An Attention Indicator Flashes - Kyocera TASKalfa 306ci Operation Manual

Troubleshooting > Indicators During Sending/Receiving Operation

Indicators During Sending/Receiving Operation

The [Processing] and [Memory] indicators show the fax transmission status.
• The [Processing] indicator blinks during fax transmission and reception.
• The [Memory] indicator blinks when source data is being stored in memory for memory transmission.
• The [Memory] indicator is lit when there is source data stored in the memory for delayed transmission.

Responding to an Attention Indicator Flashes

If the [Attention] indicator flashes, select the [Status/Job Cancel] key to check an error message. If the message is not
indicated on the touch panel when the [Status/Job Cancel] key is pressed or the attention indicator flashes for 1.5
seconds, check the following.
Symptom
Cannot send fax.
Checkpoints
Is the modular cord connected
correctly?
Is Permitted FAX No. or
Permitted ID No. registered
correctly?
Has a communication error
occurred?
Is the destination FAX line busy?
Does the destination FAX
machine respond?
Is there an error other than
above?
Corrective Actions
Connect the modular cord correctly.
Check Permitted FAX No. and Permitted
ID No.
Check error codes in the TX/RX Result
Report and Activity Report. If the error
code starts with "U" or "E", perform the
corresponding procedure.
Send again.
Send again.
Contact your Service Representative.
9-2
Reference
Page
—
8-10
9-5
—
—
—