Standard Equipment; Preparing The Machine For Operation; General; Installing The Mono Handlebar - Viking MB 443 Instruction Manual

Risk of injury!
Keep your hands and feet
away from the blades.
Cutting tool runs on for sev-
eral seconds after switching
off (engine/blade brake).
MB 443, MB 443 T,
MB 448 PT, MB 448 T,
MB 448 TX:
Starting the engine
MB 443, MB 443 T,
MB 448 PT, MB 448 T,
MB 448 TX:
Stopping the engine
MB 443 T, MB 448 PT,
MB 448 T, MB 448 TX:
Switching on self-propulsion
MB 448 PC, MB 448 TC,
MB 448 VC:
Starting the engine
MB 448 PC, MB 448 TC,
MB 448 VC:
Stopping the engine
MB 448 PC, MB 448 TC,
MB 448 VC:
Switching on self-propulsion
0478 111 9823 F - EN
MB 448 VC:
Set the driving speed.
( 11.3)

6. Standard equipment

Item Designation
A Basic unit
B Upper part of grass catcher
box
C Lower part of grass catcher
box
D Pin
– Instruction manual
– Instruction manual
for engine
MB 443, MB 443 T, MB 448 PT,
MB 448 T, MB 448 TX:
Item Designation
E Quick-clamping device
F Bolt
G Cable guide
H Protective sleeve

MB 448 PC, MB 448 TC, MB 448 VC:

Item Designation
I Sleeve
J Bolt
K Washer
L Nut
7. Preparing the machine for
operation

7.1 General

Risk of injury!
Observe the safety instructions in
the section "For your safety" (
● Place the machine on level and firm
2
ground when performing all the
operations described.
Qty.
1
1

7.2 Installing the mono handlebar

(MB 448 PC, MB 448 TC,
1
MB 448 VC)
● 1 Insert sleeve (I) in the bore on
2
handlebar (1).
1
● 2 Fit the two washers (K) with the
1
convex side facing inwards onto the
sleeve in handlebar (1).
● 3 Hold sleeve (I) and washers (K) and
insert together with handlebar (1) into
Qty.
the holder on handlebar console (2).
2
● 4 Insert bolt (J) from the outside
2
inwards through the bores in
handlebar (1) and in handlebar
2
console (2).
2
● 5 Screw on nut (L).
● 6 Tighten bolt (J). Tightening torque:
18 - 22 Nm
Qty.
1
1
2
1
4.).
3
19