Standard Equipment; Preparing The Machine For Operation; General; Assembling The Handlebar - Viking MB 650 T Instruction Manual

MB 650 V, MB 650 VS, MB 655 V,
MB 655 VS, MB 655 YS:
Setting the driving speed
Fast – Push driving
speed lever forward
Slow – Pull driving
speed lever back

7. Standard equipment

Item Designation
A Basic unit
B Lower part of grass catcher
box
C Upper part of grass catcher
box
D Pin
E Sleeve
F Bolt
G Washer
H Nut
I Mulch insert – installed in
discharge chute
– Instruction manual
– Instruction manual
Engine
46
8. Preparing the machine for
operation

8.1 General

Risk of injury!
Observe the safety instructions in
the section "For your safety" (
● Place the machine on level and firm
ground when performing all the
operations described.

8.2 Assembling the handlebar

● 1 Insert sleeve (E) in the bore
on handlebar (1).
2
● 2 Fit two washers (G) with the convex
Qty.
side facing inwards onto the sleeve.
1
● 3 Hold sleeve (E) and washers (G)
and insert together with handlebar (1)
1
into handlebar console (2) from below.
1 ● 4 Fold handlebar (1) upwards until the
bores in the handlebar console and
2
sleeve (E) are aligned.
1
● 5 Place nut (H) in the handlebar
1
console recess and hold.
2
● 6 Insert bolt (F) from the outside
1
inwards through the bores in handlebar
console (2) and the sleeve. Tighten
1
bolt (F).
1
Tightening torque: 18 - 22 Nm
● Fold down the handlebar into the
1
transport position. (
Attaching cables:
Avoid damage to the machine!
Never kink cables or damage cable
covers.
● Insert all cables (3) into the guide on
handlebar console (4). To do this,
slightly bend the cables – without
kinking them – and insert into
guide (4) as shown.
MB 650 VS, MB 655 VS, MB 655 YS:
Place the BBC cable (∅ = 7 mm) in
guide (4) first.
● Insert all cables (3) into cable guide (5).
5.).
● Fold up the handlebar into the working
position. (
● MB 655 YS:
Adjust the self-propulsion cable.
(
3
8.3 Attaching and detaching the
recoil starter rope
Attaching:
● Detach the spark plug socket from the
engine.
● MB 650 T, MB 650 V, MB 655 V:
Press the motorstop lever (1) to the
handlebar and hold.
● Slowly pull out the recoil starter rope (2)
and attach it to the rope guide (3).
● Slowly release the recoil starter rope (2)
and motorstop lever (1).
● Connect the spark plug socket.
Detaching:
● Detach the spark plug socket from the
engine.
● MB 650 T, MB 650 V, MB 655 V:
9.3)
Press the motorstop lever (1) to the
handlebar and hold.
● Slowly pull out recoil starter rope (2)
and detach it from rope guide (3).
9.3)
14.9)
0478 111 9931 B - EN
4