Advanced Settings - Njoy Balder Series User Manual

Advanced settings

8
WARNING!
First settings upon starting
the UPS for the first time
must be setting the number
of batteries. For this, see
chapter 6.9.1 (page 32).
There are three parameters to set up the UPS. Refer to following diagram.
• Parameter 1: For program alternatives. There are 16 programs to set up.
Refer to the table below.
• Parameter 2 and 3: The settings options or values for each program.
NOTE!
Most of Balder UPS parameters can be set-up only on Bypass mode (see below
table); please be sure you are in Bypass mode and then press and hold Test/Up +
Mute/Down Buttons simultaneous more than 1s to enter the setting menu (see
section 5.1 for details).
Programs available list for parameter 1:
Description
Output voltage
Output frequency
Voltage range for
bypass
Frequency range
for bypass
ECO mode
enable/ disable
24
By-
pass/
Code
No
output
01 Y
02 Y
03 Y
04 Y
05 Y
Parameter 1
88
Vac
8 8 8 8 8 8
Parameter 2
AC ECO CVCF Battery
Vac
Parameter 3
Battery
Test