Problems Related To Scan Results - Sharp MX-C402SC Operation Manual

PROBLEMS RELATED TO SCAN RESULTS

Problem
The scanned image is
clipped.
The quality of the
scanned image is
poor.
The scanned image is
blank.
The scanned image is
upside down or on its
side.
Point to check
Is the original scan size setting smaller
than the actual original size?
Is the original printed matter such as a
book or magazine?
When scanning a color or grayscale
original, is the color mode set to
"Mono2"?
Is a destination included that has
[TIFF-S] selected for the format?
Is the original placed face up or face
down correctly?
Are Internet fax addresses included in
the transmission?
Set the scan size to the actual original size.
If you have intentionally set a smaller size than the
actual original size, note carefully the placement
position of the selected scan size when placing the
original. For example, when scanning an 8-1/2" x 11"
(A4) original using a 5-1/2" x 8-1/2" (B5) setting on the
document glass, align the original using the document
glass scale at the left center to fit the area you wish to
scan into the 5-1/2" x 8-1/2" (B5) scanning area.
☞
1. BEFORE USING THE MACHINE
THE ORIGINAL ON THE DOCUMENT
(page 1-39)
Use the following method to reduce the occurrence
of vertical patterns (moiré)
When the original is printed matter, vertical patterns
(moiré) may occur. Touch the [Exposure] key in the base
screen to open the exposure setting screen. The [Moiré
Reduction] checkbox appears in this screen. This
checkbox can be selected
effect. (only in scan mode and USB memory scan mode)
It may also be possible to reduce the moiré effect by
changing the resolution setting or shifting the original (or
changing its angle) slightly on the document glass.
Setting the color mode to "Mono2" replaces the colors in
the original with either black or white. This is suitable for
text-only originals; however, for originals that contain
illustrations, it is best to use the [BLACK & WHITE
START] key with the color mode set to [Grayscale], or
set the color mode of the [COLOR START] key to [Full
Color] or [Auto]-[Grayscale] and then scan.
If you wish to send an image scanned at high
resolution to scan mode destinations, send the
image in a separate transmission.
When a broadcast transmission is performed that
includes both scan mode destinations and Internet fax
destinations that have [TIFF-S] selected for the format,
the resolution will remain fixed at [200X200dpi] even if a
different resolution setting is selected.
Reload the thermal paper correctly and send the fax
again.
When using the document glass, the original must be
placed face down. When using the automatic document
feeder, the original must be placed face up.
Send the image to the scan mode destinations in a
separate transmission.
When both scan mode and Internet fax destinations are
included in a broadcast transmission, the original
transmission orientation of Internet fax takes
precedence, and thus the file may not appear in the
correct orientation when viewed on a computer.
8-37
TROUBLESHOOTING
Solution
"PLACING
GLASS"
to reduce the moiré
Contents