Sharp MX-C402SC Operation Manual page 532

Specifying the original scan size (by paper size)
If the size of the placed original is different from the displayed original size or you wish to change the original size, you
must touch the [Original] key and directly specify the original size.
Place the original in the document feeder tray or on the document glass and follow the steps below.
Select the mode and display the image settings screen.
(1) Touch the tab of the mode that you wish to use.
1
(2) Touch the [Original] key.
The original size set in the system settings appears to the right of the [Original] key.
☞
IMAGE SETTINGS
Scan/Original
Scan Size
8½x11
2
2-Sided 2-Sided
Booklet Tablet
Scan/Original
Original Exit
Upper Exit
Place
Original Size
5½x8½ 8½x14
8½x11 8½x13
8½x13
Size Input
3
• If you are sending a long original, touch the [Long Size] key. Use the automatic document feeder to scan a long
original. The maximum width that can be scanned is 19-5/8" (500 mm) (the maximum height is 8-1/2" (216 mm)).
• To specify an AB size for the scan size, touch the [AB
• In the situations below, the original exit place is fixed to the heavy exit.
- When "Card Size" is selected
- When the original guide is set to 2 7/8" (74 mm) or lower (Except when "Check Size" is selected)
- When the automatic document feeder is scanning an original with an X (horizontal) value of 4 1/8" (105 mm) or less
• When "Card Size" is selected, you cannot copy if the original guide is set to 2 7/8" (74 mm) or higher.
Scan/Original
Scan Size
5½x8½
4
2-Sided 2-Sided
Booklet Tablet
When [Long Size] is selected, the 2-sided scanning setting and send size cannot be changed. In addition, when only scan
destinations are selected for scan transmission or metadata transmission, scanning will take place in Mono2.
(page 5-52)
OK
100% Send Size
Auto
Image Orientation
(1) (3)
OK
Heavy Exit
AB
Check Size
Inch
Long Size
Card Size
(2)
OK
100% Send Size
Auto
Image Orientation
Touch the [Scan Size] key.
Specify the scan size.
(1) Touch the original output destination.
(2) Touch the appropriate original size key.
(3) Touch the [OK] key.
Inch] key to highlight the [AB] side and then specify the scan size.
Touch the [OK] key.
5-55
SCANNER/INTERNET FAX
Contents