Electrical - Westinghouse WGen11500TFc User Manual

ELECTRICAL

GENERATOR CAPACITY
NOTICE
Do not overload the generator's capac-
ity. Exceeding the generator's wattage/amperage
capacity can damage the generator and/or electrical
devices connected to it.
Review the Specifications for this generator and record the
running (continuous) and peak (starting) watts. In general
the higher the wattage, the more devices can be powered
at the same time. The total power requirements of all con-
nected devices must be considered. Power requirements
are often listed on a device's data label or nameplate.
To determine power requirements:
l Choose the devices you want to power simultaneously.
l Record and total the running (continuous) watts of each
device. The generator must continuously produce this
amount of wattage to keep the devices running.
l Record the peak (starting) watts for each device. This is
the momentary surge of power required to start electric
motors in some tools and appliances.
l Select the device with the highest peak (starting) wattage.
Add the peak (starting) watts for that device to the total
running (continuous) watts for all the connected devices
to determine the total peak wattage requirement for the
generator.
NOTE: Total peak wattage requirement assumes inter-
mittent starting of devices. Adjust estimate if devices
reach peak wattage at the same time.
MANAGING GENERATOR POWER
To extend the service life of the generator, use caution
when adding electrical loads. Disconnect all loads before
starting the generator. The safest way to manage generator
power is to add loads sequentially by doing the following:
l Remove all loads and start the generator as described
later in this manual.
l Connect and start the largest device or appliance. Power
requirements are often listed on a device's data label or
nameplate.
l Allow the generator output to stabilize. Once stable,
the engine should run smoothly and the device should
function properly.
l Connect and start the next largest device or appliance.
l Allow the generator output to stabilize.
l Repeat this process for each additional load.
EXTENSION CORDS
WARNING
cords running directly into the home increase the risk
of carbon monoxide poisoning through any openings.
If an extension cord running directly into your home
is used to power indoor items, there is a risk of car-
bon monoxide poisoning to people inside the home.
Always use battery-powered carbon monoxide de-
tector(s) that meet current UL 2034 safety standards
when running the generator. Regularly check the de-
tector(s) battery.
WARNING
ating the generator with extension cords, make sure
the generator is located in an open, outdoor area far
away from occupied spaces with exhaust pointed
away.
WARNING
Never use worn or damaged extension cords. Dam-
aged or overloaded extension cords could overheat,
arc, and burn resulting in death or serious injury.
Before connecting an AC appliance or power cord to the
generator:
l Use grounded 3-prong extension cords, tools, and ap-
pliances, or double-insulated tools and appliances.
l Make sure the tool or appliance is in good working order.
Faulty appliances or power cords can create a potential
for electric shock.
l Make sure the electrical rating of the tool or appliance
does not exceed the rated power of the generator or the
receptacle being used.
NOTICE
Do not exceed the unit's capacity. Over-
loading the generator's wattage and/or amperage ca-
pacity could damage connected devices and critical
generator components.
EXTENSION CORD SIZING
Make sure your extension cord can carry the required load.
Cables that are too small may cause a voltage drop that
can cause the cord to overheat or cause property damage.
Refer to the cord manufacturer's guidelines for the appro-
priate size and length.
Asphyxiation hazard. Extension
Asphyxiation hazard. When oper-
Fire and electrocution hazard.
English | 13