AEMC 5070 User Manual page 43

1.800.561.8187
free Obj : Test location.
Here - 02 : 59 (the Obj. number is
that of the last measurement stored,
but the Test number is incremented
by 1).
It is always possible to modify
buttons.
If a new Obj is selected, the test
number is set to 01 automatically.
If you select a memory address that
is already occupied, the screen to the
right is displayed and prompts you
content of that address.
button.
highlight CANCEL. Then, press the
the selected memory address (whether occupied or not).
All information from the measurement will be stored at a single location in
memory: date, time, test mode and voltage, insulation resistance, capacitance,
residual current, and, possibly, DAR, PI, DD (if available), temperature corrected
resistance and the R(t) graph.
WARNING: If a button other than MEM is pressed or if the selector
switch is moved before pressing MEM a second time, the instrument
exits from MEM mode without saving the results.
Total memory space: 128 kB
Data management: 8 kB
Free memory space: 120 kB
An insulation measurement requires 80 bytes. Therefore, approximately 1500
insulation measurements can be stored.
Megohmmeter Model 5070
www.
the measurement results are recorded at
information@itm.com
.com
43