AEMC 5070 User Manual page 11

1.800.561.8187
7. START/STOP button (starts and stops measurements).
8. Eight buttons with a primary and secondary function. The secondary functions
are highlighted in yellow italics below each button:
Button
Either selects a function or increases the parameter selected by the cursor.
Holding the button increases the rate of change for the parameter.
Either selects a function or decreases the parameter selected by the cursor.
Holding the button increases the rate of change for the parameter.
MEM Saves measured values.
Before starting a test, the mode function allows selection of run time,
MODE
sample rate, DAR PI, and ratio times.
Browses through the screens accessible before, during, and after the
DISPLAY
measurement
2 nd Selects the second function of each button.
Button
ALARM Activates or deactivates the alarms programmed in SET-UP
SMOOTH Starts or stops the smoothing of displayed values during testing.
TEMP Activates temperature correction
Turns the display backlight ON or OFF
MR Recalls saved data
PRINT Printing measurement data is completed through DataView software.
Browses through the screens accessible before, during, and after the
GRAPH
measurement
Megohmmeter Model 5070
www.
information@itm.com
.com
11