Hyundai Elantra 2024 Owner's Manual page 151

5. However, the indicator (4) flashes in
Green continuously, but if the garage
door opener does not operate, please
continue to follow the step 6 and 7
("Rolling Code Programing"
procedures).
6.Firmly press and release the "Learn,"
"Smart," or "Program" button while the
indicator (4) flashes in Green. Once the
button is pressed, you have
approximately 30 seconds to initiate
the next step.
Information
At the garage door opener motor,
(security gate motor, etc.) locate the
"Learn," "Smart," or "Program" button.
This can usually be found where the
hanging antenna wire is attached to the
motor-head unit (see the device's
manual to identify this button). The
name and color of the button may vary
by manufacturer. A ladder and/or
second person may simplify the
following steps.
7. Return to the vehicle and firmly press,
hold for two seconds and release the
HomeLink button up to three times. Do
not press the HomeLink button rapidly.
At this point programing is complete
and your device should operate when
the HomeLink button is pressed and
released.
Information
• Some garage door openers require to
press the programed button on the
mirror up to three times right after the
programing is just completed to
operate the garage door.
• The indicator (4) is turned ON in Orange
and flashes for about 60 seconds,
during the programing mode and if a
programing is not succeeded within the
60 seconds, the programing mode will
be abort.
HomeLink® should now activate your
rolling code equipped device.
Gate operator & Canadian programing
During programing, your handheld
transmitter may automatically stop
transmitting. Continue to press the
Integrated HomeLink® Wireless Control
System button while you press and
re-press ("cycle") your handheld
transmitter every two seconds until the
frequency signal has been learned. The
indicator light will flash slowly and then
rapidly after several seconds upon
successful training.
OCN7050085N
Operating HomeLink®
1. Press and release one of the HomeLink
buttons (1, 2 or 3) that programed.
2. The HomeLink indicator (4) will operate
as below:
• Indicates Green and is continuously
ON (Fixed Code Garage Door
Opener)
• Flashes in Green rapidly (Rolling
Code Garage Door Opener)
5
5-35