Chapter 6 Connecting The Scanner Using The Scsi Interface; Setting Up The Scsi Interface; Setting The Scsi Id Number - Epson GT-20000N Pro User Manual

Chapter 6
Connecting the Scanner Using the SCSI Interface (for
Windows Only)

Setting Up the SCSI Interface

You can also connect the scanner and computer using the SCSI interface. Unless your
computer already has a SCSI board installed, you need to install one, along with SCSI
driver. Install the SCSI board according to the directions included with it.
Limitations of the interfaces:
The scanner is equipped with built-in USB and SCSI interfaces. If you have installed the
optional Epson Network Image Express Card or a special card for a copy system in the
optional interface slot, your scanner has a third additional interface. Simultaneous access
with these different interfaces, however, is not guaranteed.
Note:
❏ Be sure to install the scanner software before connecting the scanner to your computer. See
the Start Here sheet for instructions.
❏ You will need to install the SCSI driver that is normally included with Windows or your SCSI
board.
If your computer has a SCSI board up and running, see "Setting the SCSI ID Number" on
page 88.

Setting the SCSI ID Number

The scanner's default SCSI ID number is 2.
Connecting the Scanner Using the SCSI Interface (for Windows Only)
GT-20000 User's Guide
88