Rockwell Automation ICSTT-RM280N-EN-P Manual page 31

Trusted TMR 24Vdc Digital Output Module – 40 Channel
The FCR Status channel reports the fault status of the Active and Standby Modules. The
value is bit-packed as shown below, the least significant byte is used with the most
significant 8-bits set to zero:
Bit
7 6
Standby Module
Ejectors FCR C
open Healthy
The 'Primary Module is active' channel is set to non-zero if the primary Module is the
current Active Module, i.e. the Active Module is in the chassis and slot numbers defined
within the OEM parameters.
The 'Active Module is simulated' channel is set to non-zero if the Active Module is being
simulated, this will only be set if the Module is not present or the simulation enable has
been set within the Module's configuration in the System.INI file.
Rockwell Automation Publication ICSTT-RM280N-EN-P
Value Module Mode
5 Shutdown
4 Maintain
3 Active
2 Standby
1 Configuration
0 Unknown, no Module present
Table 14 Rack 8 INFO bit Descriptions
5 4
FCR B FCR A
Healthy Healthy
Table 15 Rack 8: FCR bit Descriptions
3 2 1
Active Module
Ejectors FCR C FCR B
open Healthy Healthy
Issue 14
3. Application
0
FCR A
Healthy
23