66 of 76
7 Operation
7.4.5 Information
Table 40: Displaying information
Step 1: Activating the additional function setting mode
▪ Press and hold the control button for 10 seconds.
– The additional functions setting mode is active.
Step 2: Selecting Information
▪ Turn the dial and select the required function.
Inf
Step 3: Confirming the setting
▪ Press the control button.
– The pump size and the current firmware version are briefly
shown on the display.
– The display then changes automatically to its normal
operating display.
7.5 Resetting to factory settings
To reset the pump set to factory settings press the control button (●) for more than
30 seconds.
Table 41: Factory settings
Operating mode
Functions
Setpoints
Modbus parameter baud rate
Modbus parameter slave ID
Modbus parameter parity
CalioTherm Pro
Constant-pressure Control
The Dual, Modbus, 0 - 10 V functions are disabled.
60 %
19,200 baud
17
Even