KSB CalioTherm Pro 25 Installation & Operating Manual page 21

5 Installation at Site
Positioning the control panel
Insufficient stability
Risk of crushing hands and feet!
▷ During assembly/dismantling, secure the pump (set)/pump parts to prevent
Fig. 6: Placing the pump set down safely
The control panel can be turned. Positioning must be carried out with the pump set
removed from the system.
ü The pump set is secured against tipping over.
1. Undo and store the 4 hexagon socket head cap screws.
2. Rotate the control panel until it has reached the required position. Compare it
3. Fit and tighten the 4 hexagon socket head cap screws again. Tightening torque
Permissible installation positions
Fig. 7: Permissible installation positions
Screw-ended pump 1. Position the pump set as indicated in an easily accessible place.
2. Accurately insert the sealing element.
3. Connect the pump and piping with a pipe union.
4. Tighten the pipe union hand-tight with a suitable tool.
5. Accurately insert the sealing element in the opposite pipe union.
6. Tighten the pipe union hand-tight with a suitable tool.
CalioTherm Pro
WARNING
tilting or tipping over.
against the permissible installation positions. Adjust the position if required.
= 7 to 9 Nm
ð An arrow on the pump casing and thermal insulation shell indicates the
direction of flow.
21 of 76