KSB CalioTherm Pro 25 Installation & Operating Manual page 48

48 of 76
7 Operation
Table 20: Selecting Eco Mode and the setpoint
Step 1: Activating the setting mode
▪ Press and hold the control button for 3 seconds.
– The operating mode which has last been selected will start
flashing.
Step 2: Selecting the Eco Mode operating mode
▪ Turn the dial and select the required operating mode.
▪ The symbol lights up in green.
Step 3: Activating the Eco Mode operating mode
▪ Press the control button.
– The number of flashing LED segments shows the setpoint
which has last been set.
Step 4 a: Confirming the current setpoint
▪ Press the control button.
Step 4 b: Changing the setpoint
▪ Turn the dial and set the required setpoint in increments of
1 % within the range from 0 % to 100 %.
– Turning it clockwise increases the setpoint; turning it anti-
clockwise decreases the setpoint.
– The LED segments will light up in increments of 10 %.
▪ Press the control button to save the setpoint.
NOTE
If 10 seconds pass without any settings being made or saved, the control unit will
revert to the previous settings.
NOTE
To start the pump the "RUN" terminal pair must be bridged (factory setting) or the
terminal pair must receive the START signal.
CalioTherm Pro