Operation; Control Panel; Display; Operating Modes - KSB CalioTherm Pro 25 Installation & Operating Manual

Table 16: Overview of settings using the control button
Menu

Operating modes

Functions
5)
Additional functions
Resetting to factory settings
5 Depending on the model / firmware version
40 of 76

7 Operation

7 Operation

7.1 Control panel

All settings are made using the control element on the housing front.
The control element consists of a dial and a control button. The control button is
arranged in the middle of the dial and can be pressed down.
Setpoint values can be adjusted by turning the dial in increments down to a
minimum of 0 %. The setpoint value is shown as a numerical value on the display.
10 LED segments are arranged around the dial. These segments represent setpoint
values ranging from 0 - 100 % in increments of 10 %. The LED segments light up in
blue when settings are being made at the pump. In the following example the
setpoint = 40 %.
NOTE
If set to 100 %, the performance limits may cause the actual value to be slightly
below the maximum characteristic curve, depending on the pump and operating
point.
%
I
II
III
Fig. 18: Control element
I Dial
II Control button
III 10 LED segments (lit up in blue when pump settings are being made)
Settings overview
Time to open menu
Press and hold the control button for
3 seconds.
Press and hold the control button for
5 seconds.
Press and hold the control button for
10 seconds.
Press and hold the control button for
30 seconds.
CalioTherm Pro
Details
(ð Section 7.2, Page 42)
(ð Section 7.3, Page 51)
(ð Section 7.4, Page 61)