Siemens FS720 Mounting & Installation page 21

Building Technologies
Fire Safety
1 Large rear panel
2 Holes for wall mounting (top)
3 Fastening tabs for the cover cap
4 Openings for cable feed from rear side
5 Recesses for the hinges of the operating unit
6 Mounting holes for operating unit
7 Periphery board (4 loops)
8 Secondary-side cabling of the power supply
9 Recesses for the hinges of the operating add-on
10 Mounting holes for the operating add-on
11 Power supply (150 W)
12 DIN rail for additional components
13 Holes for wall mounting (bottom)
14 Primary-side cabling of the power supply
15 DIN rail with network separation terminals and for additional components
16 Strain relief for mains supply cable
17 Card cage (5 slots) for module bus cards.
18 Mounting plate with slots for fastening the shield connection terminal blocks
The mounting plate, as a carrier for the periphery board and the card cage, is
1
offset around 2 cm from the rear panel. The cables of the external supplies and
power line can then be led behind the mounting plate.
Overview
Station rear panels (packaging unit)
A6V10210390_m_en_--
3
1
21 | 248
2018-08-29