Using Command History; Saving Your Configuration; Figure 143 Cli: History Command Example; Figure 144 Cli: Write Memory - ZyXEL Communications GS-4024 User Manual

GS-4024 User's Guide
To enter Enable (or privileged) mode, type
default is 1234). When you enter the Enable mode, the command prompt changes to the pound
sign ( ).
#
To enter the configuration mode, type
command prompt consists of the word "
sub configuration modes: interface, router and VLAN.
• To enter config-vlan mode, type
example,
• To enter config-interface mode and configure the ports, enter
channel
• To configure the routing domain, enter
domain IP address and subnet mask bits (for example,
192.168.1.1/24
• Use the
Enter
exit

39.7 Using Command History

The switch keeps a list of up to 256 commands(s) you have entered for the current CLI
session. You can use any commands in the history again by pressing the up ( ) or down ( )
arrow key to scroll through the previously used commands and press
command to display the list of commands.

Figure 143 CLI: History Command Example

ras> history
enable
exit
show ip
history
ras>

39.8 Saving Your Configuration

After you set the switch settings with the configuration commands, use the
command to save the changes permanently.

Figure 144 CLI: write memory

ras# write memory
226
to configure settings for VLAN 10.
vlan 10
followed by a port number. For example,
).
commands to configure the routing protocol settings.
router
or to quit from the current mode or log out from the CLI.
logout
and enter a password when prompted (the
enable
or
configuration config
" and the pound sign (
config
followed by a number (between 1 to 4094). For
vlan
interface port-channel 10
interface route-domain
interface route-domain
Chapter 39 Introducing the Commands
. The Configure mode
). There are various
#
interface port-
.
followed by the
. Use the history
[ENTER]
write memory