Table of Contents
Advertisement
Load carrier
Load carrier
-
-
When loaded, the vibratory roller is centered laterally on the platform (± 5 cm).
When loaded, the vibratory roller is centered laterally on the platform (± 5 cm).
-
-
The parking brake is applied and in good working condition, and the articulated joint lock is
The parking brake is applied and in good working condition, and the articulated joint lock is
closed.
closed.
-
-
The drum is placed on a rubber liner, so that the static friction between the surfaces is at least
The drum is placed on a rubber liner, so that the static friction between the surfaces is at least
0.6.
0.6.
-
-
The contact surfaces must be clean, wet or dry, and free from frost, ice and snow.
The contact surfaces must be clean, wet or dry, and free from frost, ice and snow.
-
-
The lashing mounts on the load carrier have LC/MSL at least 2 tonnes.
The lashing mounts on the load carrier have LC/MSL at least 2 tonnes.
Lashings
Lashings
-
-
The lashings comprise a lashing strap or chain with a permitted load (LC/MSL) of at least 1.7
The lashings comprise a lashing strap or chain with a permitted load (LC/MSL) of at least 1.7
tonnes (1,700 daN) and a pre-tension S
tonnes (1,700 daN) and a pre-tension S
re-tightened as required.
re-tightened as required.
-
-
Each of lashings 1-3 is either a double or two single lashings. A double lashing runs in a sling
Each of lashings 1-3 is either a double or two single lashings. A double lashing runs in a sling
through a lashing point or around a machine part and down into two different mounts on the
through a lashing point or around a machine part and down into two different mounts on the
platform.
platform.
-
-
Lashings in the same direction are placed in different lashing mounts on the trailer. Lashings
Lashings in the same direction are placed in different lashing mounts on the trailer. Lashings
that are pulled in opposite directions may be placed in the same lashing mount, however.
that are pulled in opposite directions may be placed in the same lashing mount, however.
-
-
The lashings are as short as possible.
The lashings are as short as possible.
-
-
The lashing hooks must not lose grip if the lashings become slack.
The lashing hooks must not lose grip if the lashings become slack.
-
-
The lashings are protected against sharp edges and corners.
The lashings are protected against sharp edges and corners.
-
-
The lashings are located symmetrically in pairs on the right and left sides.
The lashings are located symmetrically in pairs on the right and left sides.
88
of at least 300 kg (300 daN). The lashings are
of at least 300 kg (300 daN). The lashings are
TF
TF
4812159001_I.pdf
Miscellaneous
2019-11-05
Advertisement
Table of Contents
