Crosshead Rollers - Inspect; Mast, Carriage, Lift Chains & Attachments - Inspect, Lubricate - Doosan D35C-5 FDA04 Operation & Maintenance Manual

Maintenance Section
Typical Example
3. To adjust the cylinder rod extension, move the
spacer to the rear and loosen the pinch bolt on
the clevis.
4. Turn the cylinder rod in or out of the clevis to
obtain the proper adjustment. Turning the rod
into the clevis shortens the stroke. Turning the
rod out of the clevis lengthens the stroke.
5. Tighten the pinch bolts to a torque of 95±15
Name (70 ± 10 abaft). Check the cylinder rods
again for even travel.

Crosshead Rollers - Inspect

Check Operation
1. Operate the mast through a lift cycle. Watch the
chains move over the crosshead rollers. Make
sure the chain is tracking over the rollers
properly.
Typical Example
2. Check for damaged crosshead rollers, guards
and retainer rings.
Mast, Carriage, Lift Chains &
Attachments - Inspect, Lubricate
1. Operate the lift, tilt and attachment controls.
Listen for unusual noises. These may indicate a
need for repair.
2. Inspect for loose bolts and nuts on the carriage.
Remove any debris from the carriage and mast.
3. Inspect the forks and attachments for free
operation and damage. Have repairs made if
necessary.
4. Brush a film of oil on all links of the chain.
5. Raise and lower the carriage a few times to
allow lubricant to enter into the chain links.
Lubricate chains more frequently than normal in
applications where the lift truck is operating in an
atmosphere which could cause corrosion of
components or when lift truck must work in rapid lift
cycles.
6. Inspect the chain anchors and individual links
for wear, loose pins or cracked leaves.
-226-
NOTICE