Doosan D35C-5 FDA04 Operation & Maintenance Manual page 97

After Starting the Engine
Observe all indicator lights and gauges frequently
during operation, to make sure all systems are
working properly. The entire indicator lights will
come ON with the ignition switch in the ON position
before the engine is started.
Diesel (12V)
4 2
1
5
LPG/GAS (12V)
2
1
5
1. The engine oil pressure indicator light (1), will
not come ON with the engine running, unless
there is low or no oil pressure. Stop the engine
immediately, if the light comes ON.
2. The alternator indicator light (2), should not
come ON during normal operation. The
alternator is not charging if the light comes ON
with the engine running.
3. The spark-ignition
G430FE engine
Light)(3) will not come ON with the engine
running, unless the fault or faults are stored in
the memory
module(ECM). Stop the engine and check the
electric engine control system if the light
comes ON. Refer G424P(E)/G424I(E)/G430FE
Engines of this section.
6 7
6 7
G424P(E)/G424I(E)/
MIL(Malfunction Indicator
of the engine control
4. The diesel engine water in fuel filter indicator
light(4), will not come ON with the engine
running, unless water in fuel filter exceeds
100cc. Stop the engine immediately and drain
the water if the light comes ON.
5. Observe the fuel level gauge (5) for fuel level
in the tank.
6. The engine coolant temperature gauge pointer
(6) will be in the green band with the engine
running, unless the coolant temperature is
excessive.
7. The transmission
pointer (7) will be in the green band with the
engine running, unless the oil temperature is
excessive.
8. Observe the hour meter (8) to make sure it is
operating properly.
-95-
Operation Section
oil temperature gauge
8