Doosan D35C-5 FDA04 Operation & Maintenance Manual page 99

7. To change the lift truck direction of travel,
release the accelerator pedal.
8. Push down on the service brake pedal to
reduce the lift truck speed as necessary.
9. Move the directional lever to the desired
direction of travel. Slowly push down on the
accelerator pedal as the lift truck changes
direction.
10. When the direction change is completed,
continue to push down on the accelerator pedal
to obtain the desired travel speed.
11. To stop the lift truck when traveling in either
direction, release the accelerator pedal.
12. Push down on the service brake pedal and
bring the lift truck to a smooth stop.
Inching
NOTE: The purpose of the inching pedal is to
provide precise lift truck inching control at
very slow travel speed and high engine
rpm. This is used for fast hydraulic lift,
during load approach, pick up or load
positioning.
1. To inch (creep) in either direction, slowly push
down on the inching pedal. This will start to apply
the service brakes and allow the transmission
clutch discs to slip.
2. Vary the position of the inching pedal and the
accelerator pedal to control the inching speed
and distance.
3. Pushing down further on the inching pedal will
disengage the transmission completely and
apply the service brakes fully to stop and hold
the lift truck. This will provide full engine power
for fast hydraulic lift.
4. Avoid overuse of the inching pedal as this may
cause the automatic transmission oil to overheat
or the clutch to slip. Do not use as a footrest or
for long periods of time.
5. If user operates continuously pushing work or
both brake pedal and accelerator pedal were
depressed at the same time, it may cause the
automatic transmission oil to overheat or the
clutch to slip.
Do not use inching pedal instead of brake
pedal.
It will give wearing to transmission clutch disc.
-97-
Operation Section
WARNING