Table of Contents
Advertisement
1
2
Figure 10
1. Parking brake-ON
2. Parking brake-OFF
Starting and Stopping the
Engine
Starting the Engine
1. Sit on the seat and move the motion controls to neutral
locked position.
2. Set the parking brake; refer to Setting the Parking
Brake, page 18.
3. Move the PTO (power take off) switch to the off
position (Fig. 11).
4. Move the choke control to the on position before
starting a cold engine.
Note: A warm or hot engine may not require choking.
After engine starts, move choke control to run position.
5. Move the throttle control to the fast position before
starting a cold engine.
6. Turn the ignition key to start. When the engines starts,
release key.
Important
Do not engage starter for more than
10 seconds at a time. If engine fails to start allow
30 second cool-down period between attempts. Failure to
follow these instructions can burn out starter motor.
7. After the engine starts, move the choke to off
(Fig. 12). If the engine stalls or hesitates, move the
choke back to on for a few seconds. Then move the
throttle lever to desired setting. Repeat this as
required.
All manuals and user guides at all-guides.com
3
m–4163
3. Brake Stop
19
2
1
m–4201
Figure 11
1. PTO-On
2. PTO-Off
1
2
m–2720
Figure 13
1. Throttle–Fast
2. Throttle–Slow
Stopping the Engine
1. Push the PTO to the off position (Fig. 13).
2. Move the throttle lever midway between the slow and
fast positions (Fig. 13).
3. Let the engine idle for 60 seconds (Fig. 14).
4. Turn the ignition key to the off position and remove
the key (Fig. 14).
5. Close the fuel shut off valve before transporting or
storing the machine (Fig. 45).
Important
Make sure that the fuel shut off valve is
closed before transporting or storing the machine, as fuel
leakage may occur. Set the parking brake before
transporting. Make sure to remove the key as the fuel
pump may run and cause the battery to lose charge.
2
1
m–2719
Figure 12
1. Choke–On
2. Choke–Off
1
2
3
M–4268
Figure 14
1. Off
2. Run
3. Start
Advertisement
Table of Contents
