Getting Started - Read This Page - MAGUIRE Weigh Scale Blender 4088 Installation Operation & Maintenance

Getting Started – Important!
Safety Notifications and
Safety Hazards
Blender Part Identification
Assembly and Installation
Instructions
Wiring Considerations
Model Selection
Touchscreen Key Parts
Touchscreen Overview
Mode of Operation
Enable / Disable
Material Type Outputs
Check Out Procedure
Load Cell Calibration
Material Flow Rate
Calibration
Normal Operation &
Saving the Configuration
Lockout/Tagout, Cleaning,
Maintenance.
Page: 8 HAZARDS exist on this unit.
Read Safety Notifications and Safety Hazards.
Page: 10 Identifying key parts and what they do.
Page: 12 Assembly and installation instructions.
Page: 17 How to minimize electrical interference.
Page: 18 How to verify and change your model selection. All new
blender controllers are pre-configured with the model from
factory. New, spare or swapped controllers may require a
model change.
Page: 20 Identifying the key parts of the blender controller.
Page: 21 Understanding the Touchscreen home screen.
Page: 25 This section selects the general Operating Mode of the
machine (Blender, Dispenser, Totalizer) and sets the Blend
Mode as: Additive are dispensed as a % of Natural or
Materials are a % of Total Batch.
Page: 26 To "Enable" a component, the TYPE must be selected as:
REGRIND, NATURAL, or ADDITIVE. Each TYPE is
controlled differently by the MATH routines. The controller
must know the material TYPE to know how to dispense the
setting. This is IMPORTANT. Be SURE you
UNDERSTAND this section and Mode of Operation before
operating the blender.
Page: 30 Step by step procedure to verify correct assembly.
Page: 35 Load Cells of new blenders are calibrated at the factory.
However shipping or rough handling can create load cell
problems. If weight readings are not correct, you MUST
recalibrate the load cells.
Page: 37 A flow rate calibration is not necessary because the blender
will learn the flow rate over time however if you change
equipment or material you may want to re-calibrate the
material flow rate.
Page: 43 How to start the blender and save / restore the
configuration.
Page: 99 How to Lockout/Tagout, Clean and Maintain your blender.
7